| RFID Reader Module |
|
-
The Parallax Radio Frequency Identification (RFID) Reader Module is the first low-cost solution to read passive RFID transponder tags from up to 4 inches away.
|
|
| EmbeddedBlue Connect PC Adapter |
 |
-
The eb600 includes an AppMod header which is designed to connect to the EmbeddedBlue Transceiver AppMod . Using these 2 EmbeddedBlue products, you will gain Bluetooth connectivity for devices containing a RS-232.
|
|
| EmbeddedBlue Transceiver AppMod |
|
-
The EmbeddedBlue Transceiver AppMod provides standard Bluetooth connectivity for BASIC Stamp applications without the need for detailed Bluetooth knowledge.
|
|
| SureLink 900 MHz RF Module |
|
-
This transceiver has a range of up to 1000 feet! Includes selectable transfer rates and has 128 byte scratch pad flash memory. Connects easily to the QuickLink Demo Board (shown below)
|
|
|
| SIP/Dual-Mode Transmitter |
|
-
Dual mode, 9600, N, 8, 1 encoded serial and switch commands. Built-in RF noise filtering. High Performance loop antenna. Longest range at 250 feet, does not require a ground plane.
|
|
| SIP/Dual-Mode Receiver |
|
-
Dual mode, 9600, N, 8, 1 encoded serial and switch commands. Built-in RF noise filtering. High Performance loop antenna. Longest range at 250 feet, does not require a ground plane.
|
|
| SIP/Dual-Mode Transceiver |
|
- It
includes the capability of driving one or two stepper motors, each of which being either unipolar (4-pole) or bipolar (2 pole).
|
|
| SIP/Solid Antenna Receiver |
|
- It
is a complete, serially controlled, drive system for unipolar stepper motors. The desired operating speed, ramp time and drive mode can be configured once and then a single command used as required, to move to fixed or relative positions.
|
|
| SIP/Solid Antenna Transmitter |
|
-
These RF modules are used to send remote control data back and forth between two or more BASIC Stamp modules. Transmission range is 150 feet and the solid antenna is 2 inches long.
|
|
| SIP/Solid Antenna Transceiver |
|
-
These RF modules are used to send remote control data back and forth between two or more BASIC Stamp modules. Transmission range is 150 feet and the solid antenna is 2 inches long.
|
|
| 418 MHz Receiver |
|
-
This is a 7 pin module that plugs into your Parallax programming Board( i.e. Board of Education® programming board, NX-1000 Board). Transmission range is 75 feet. The pair is used to send and receive up to five remote control commands.
|
|
| 418 MHz Keychain Transmitter |
|
-
This device operates in switch mode - press a button on the keychain transmitter and the receiver pin goes "high". The transmitter has five buttons and the receiver has five outputs. The pair is used to send and receive up to five remote control commands.
|
|
|
RF Vocabulary
Package Type
- SIP = single in-line package
- KC = keychain
- AM = AppMod (plugs into Parallax boards: Board of Education carrier board, BASIC Stamp Activity Board, BASIC Stamp Super Carrier Board)
- CB = carrier board (holds BS2-style 24-pin modules)
|
Antenna Type
- loop = built-in trace antenna
- wire = 7-inch wire antenna
- solid = fixed 2-inch antenna
|
PBASIC software
- sw = switch mode (transmit pin goes high -- receiver pin goes high)
- raw = raw data (Stamp SEROUT command with error checking)
- enc = encoded data (Stamp SEROUT command)
|
| Example: 418 TX RF (KC/loop/sw) is a 418 MHz transmitter with keychain compatibility, built-in loop antenna and switch mode data. |
|
